Gas Boilers & BurnersImported & distributed

Wall-hung combi and system condensing boilers for apartments, floor-standing and cascade units for buildings, gas and oil burners, plus the boiler-room hardware around them — manifolds, circulators, expansion vessels, flues and controls. Sized against the real heat load, supplied as one package, documented for the gas certification file.

Because we buy gas Boilers & Burners directly from the factories, the range you see is the range we can programme — not a catalogue we hope to source later. In practice that means combi Condensing Boilers, system Boilers and floor-Standing & Cascade, each with its own price band and availability, so a specification can be tuned to a budget instead of abandoned.

Sized to the heat load, not the catalogue: an oversized boiler short-cycles, wears out and costs more to run. We size from the heat-loss figures for the actual building.

A boiler two sizes too big costs more to buy, more to run, and dies sooner. Getting the size right is the cheapest upgrade in the room.

Specifying gas Boilers & Burners well comes down to a short list of decisions taken in the right order — size to the building, then check turndown, design for a boiler that actually condenses, plan the flue with the boiler and get the paperwork sorted. Taken on paper, these cost nothing. Taken on site, each one is a change order.

We write the specification with you before anything is quoted, so the number you get is for the material that will actually be installed. That means confirmed dimensions and finishes, the right performance class for the space, and quantities that include the waste factor rather than discovering it mid-installation.

The same reference behaves differently depending on where it goes — apartments and houses, apartment blocks and cascades, hotels and guesthouses and offices and clinics each carry their own requirements, and we specify against the space rather than against a mood image.

Almost every delay we are called in to rescue traces back to the same handful of causes: sizing on floor area alone, fitting a modern boiler to an old system, forgetting the condensate drain and mixing control brands blindly. None of them are exotic, and all of them are avoidable at specification stage.

Sizing on floor area alone is the most expensive one, because insulation and hot-water demand change the right size far more than square metres do.

We have supplied gas Boilers & Burners into apartments, apartment blocks & hotels and offices & clinics, and the pattern is consistent: the projects that run smoothly are the ones where the material was locked before the trades were booked.

Fitting a modern boiler to an old system — checked once on paper, never again on site.

Standard lead time on gas Boilers & Burners is 1–2 weeks from confirmed specification, and that window covers the whole chain — factory programming, consolidation, transport, customs where applicable and delivery to site or to your warehouse. We quote the landed number, not an ex-works price that grows later.

Pricing is per project rather than per line. Because we import directly and consolidate gas Boilers & Burners with the rest of the materials for the same room, you get one quote, one delivery window and one point of contact — and the savings show up on the total, not just on a headline reference.

If you already have drawings, send them and we will come back with a specification and a landed price. If you do not, we will build the specification with you first. Either way, nothing is ordered until the quantities, finishes and dates are agreed in writing.