Wood & Melamine PanelsImported & distributed

Melamine-faced chipboard, raw and lacquered MDF, HPL laminate, natural veneer, plywood and moisture-resistant boards for kitchens, wardrobes and joinery workshops. We supply full sheets or cut-to-size parts with matching edge banding, so a cutting list becomes a box of finished components instead of a pile of panels and a jigsaw.

Because we buy wood & Melamine Panels directly from the factories, the range you see is the range we can programme — not a catalogue we hope to source later. In practice that means melamine-faced chipboard, MDF & lacquered MDF and HPL laminate, each with its own price band and availability, so a specification can be tuned to a budget instead of abandoned.

Cut to your list, not sold as raw sheets: send the cutting list and parts arrive sized and edged, ready for assembly instead of a stack of full boards to break down on site.

A cabinet doesn't fail because of the panel. It fails because of the edge that was never sealed and the cut that was never square.

Specifying wood & Melamine Panels well comes down to a short list of decisions taken in the right order — send us the cutting list, not just the panel choice, specify moisture-resistant board near any water source, match the edge band to the decor, not just the colour name and order from one batch for a full room. Taken on paper, these cost nothing. Taken on site, each one is a change order.

We write the specification with you before anything is quoted, so the number you get is for the material that will actually be installed. That means confirmed dimensions and finishes, the right performance class for the space, and quantities that include the waste factor rather than discovering it mid-installation.

The same reference behaves differently depending on where it goes — kitchen cabinet manufacturing, wardrobe and joinery workshops, shopfitting and retail units and office furniture production each carry their own requirements, and we specify against the space rather than against a mood image.

Almost every delay we are called in to rescue traces back to the same handful of causes: leaving a cut edge unbanded, ordering panels from different batches for one room, using standard board under a sink and skipping a squareness check on cut panels. None of them are exotic, and all of them are avoidable at specification stage.

Leaving a cut edge unbanded is the most expensive one, because a raw MDF or particleboard edge absorbs moisture and swells fast — every cut edge on a panel should be banded, not just the visible ones.

We have supplied wood & Melamine Panels into kitchens, wardrobes & joinery and offices & retail fit-out, and the pattern is consistent: the projects that run smoothly are the ones where the material was locked before the trades were booked.

Ordering panels from different batches for one room — checked once on paper, never again on site.

Standard lead time on wood & Melamine Panels is 1–3 wks from confirmed specification, and that window covers the whole chain — factory programming, consolidation, transport, customs where applicable and delivery to site or to your warehouse. We quote the landed number, not an ex-works price that grows later.

Pricing is per project rather than per line. Because we import directly and consolidate wood & Melamine Panels with the rest of the materials for the same room, you get one quote, one delivery window and one point of contact — and the savings show up on the total, not just on a headline reference.

If you already have drawings, send them and we will come back with a specification and a landed price. If you do not, we will build the specification with you first. Either way, nothing is ordered until the quantities, finishes and dates are agreed in writing.